Search:

Good evening Chris,

Thank you for the information.
On diagnosis1 I can see that I am missing input No 0000 bit2 / Power safety.
Now I know where to seek.

Gert

PS. You made pictures of...

Hello Chris,

Of course I can live with some days (but the sooner this irritating problem is solved the better).

On the diagnosis pages you can see the status of in- and output signals.
Par...

Hello Chris,

The machine was functioning well for one week.
Everything was ok but at once no higher voltage (EDM) when program starts.
When the machine was working I did not notate some...

Hello Chris,

Just for information.
The J on the resistor stands for tolerance code and not as I mentioned for MOR series.
In this case 200 Ohm +/- 5%
The picture is clear.

Gert

Hello Chris,

I first reacted on your private message and afterwards read the message "Blown item"
Thanks again for answering.
Because the fan of the U-V- axis unit was blocked by dirt (see...

Hello Chris,

If one of the following signals is missing then the machine will (also) react as you described.
Splash guard, safety cap wire and relay meter (water resistance).

Best Regards,...

Just bought a Fanuc wire cutter. Problem: no EDM power.
Resistor R51 has blown out. It's placed between 2 connectors on top/at the right side of the discharging board (DSC PCB).
Because I cannot...