Search:

Here is a link to a post I put in the UCCNC forum that shows my first job done on the refurbed Multicam router. Very happy with this product. My machine purrs like a happy little kitten.
...

So here's the scoop... I contacted Arturo about this issue and he responded right away to make me aware that the C25 board was not compatible with the M45 motherboard for the UC300ETH. PHEWWWWWY! I...

Perfect! Thanks Gerry!!! I will try all this once I figure out why none of my inputs are working. I posted this in a different thread...
...

@ger21, excuse me if my question sounds weird... Let's say the location of the area where I actually want to set to be 0,0 is "forward" of the home sensors. So from that point being 0,0 - my home...

Hi, I am using the UC300ETH board on an M45 motherboard with a C25 breakout board attached. All the outputs are working well and I am successfully controlling 4 motors with those outputs. I hooked up...

@ger21 - This is the machine I purchased your 2017 screenset for. I wanted to be able to do the tool height setting easily as the machine came with the height setter sensor plate. I will keep you...

I found a good deal for a 5' x 12' Multicam MG205 CNC router on Ebay. I have spent the last two weeks completely gutting it and retrofitting it. It had stepper motors that I replaced with clearpath...

I found a good deal for a 5' x 12' Multicam CNC router on Ebay. I have spent the last two weeks completely gutting it and retrofitting it. It had stepper motors and was pretty slow and noisy. I...

I found a good deal for a 5' x 12' Multicam CNC router on Ebay. I have spent the last two weeks completely gutting it and retrofitting it. It had stepper motors and was pretty slow and noisy. I...

This is a very interesting pluggin. Do you think this will work with this VFD that is on my router?

https://www.yaskawa.com/products/drives/industrial-ac-drives/microdrives/v7-drive

I would...