hiwins like the lg and ag series with grease lubrication can be used in any direction. hiwins with self-lubrication need certain orientations.
Type: Posts; User: jscavitto
hiwins like the lg and ag series with grease lubrication can be used in any direction. hiwins with self-lubrication need certain orientations.
I need 10 1/2 inch diameter 304 stainless steel rods 4 @ 36.375 inches and 6 @ 35.875 inches which need to be drilled and taped with 1/4-20 threads about 1 inch deep in each end.
I can supply...
if you are working with full sheets I would go with 10ft csr. I would not do a butt joint as you would most certainly see it in the finish piece when you hit the joint.
yes painting the part that the carriages don't ride on
My crs was coated in some type of grease to clean I used wd40 then simple green then denatured alcohol.
The blue painters tape worked fine for me.
I used a primer and allowed that to dry for...
On your flat plate that bolts to the bottom of the 3060 profiles is that aluminum or steel? How thick?
I ask because I have a similar setup using the 10 series 8020 i.e. 2040 and was thinking of...
my 10' csr was a little off but not as much as yours... can you clamp the gap shut?
Really so long as you can drill the mounting holes in a straight line you should be able to bend it in. The...
Hey Joe, Did you get those Hamlin units mounted?
Probably not want you really want but I did some work on a date coder application a long time ago.
Something like this
http://www.parallax.com/dl/docs/prod/robo/InkjetKitDocs-v1.0.pdf
There...
Hoss is the only diy I've seen
http://www.hossmachine.info/forum/yaf_postst4_Hoss-16-Tool-Automatic-Tool-Changer.aspx
http://www.hossmachine.info/
I doubt you will see much deflection vertically (up and down) with 8 inches I would be concerned with deflection from pushing and pulling the bit across the table because you will only have 1/4 inch...
The problem would be deflection from the weight or rather the cutting force when in use.
2020 is pretty light to go that distance unsupported but that does not mean you can't use it but you just...
you should look at the 80/20 deflection calculator however it won't account for the crs.
Assuming a single beam accoss that is supported on each end and a center load of 30 pounds you will...
I did something similar 2040 with 1/4 crs on it.
I used the econo tnuts from 80/20 and 1/4-20 5/8 cap with a washer and lock washer to attach mine
Just an idea here…. you might want to check your humidity in the winter months we usually have less humidity…. so you might want to try a humidifier to help combat the static