Hello
Please, see this:
https://www.youtube.com/watch?v=EgNhxC-oCyY
or this:
https://www.youtube.com/watch?v=EgNhxC-oCyY&index=2&list=PL8rO7rYBOj5dzymB3X2bs1GZxNkkC8iv2
Type: Posts; User: Lary
Hello
Please, see this:
https://www.youtube.com/watch?v=EgNhxC-oCyY
or this:
https://www.youtube.com/watch?v=EgNhxC-oCyY&index=2&list=PL8rO7rYBOj5dzymB3X2bs1GZxNkkC8iv2
Hi Deadlykitten
Thank you for information that you share.
Maybe I not explained properly. I don't plan to use NC program (generated from you) for manufacturing of detail.
I need this NC...
Sorry for delay!
1. Yes, my machine have Y axis.
Here are commands:
"...
3-3-2. Y-axis Control Commands
Y-axis Control Mode Commands
Use the following G codes to enter or exit Y-axis control...
Do you can give me dummy NC program for shaft similar to my drawing?
Hi
Please see attached file.
We plan eccentric turning after thermal treatment.
294966
Drawing is attached in PDF format.
Hello
Sorry for delay.
Attached is shaft in STEP format.
Thank you again for you help.
Hello
I need info about turning eccentric shaft (camshaft) at OKUMA Multus machine.
If someone have experience with this type of turning, can you share some dummy NC program of this proccess?
...
Yes, it's possible, of course!
You must to use Postbuilder application for editing of postprocessor.
Please, see this:
http://www.hostaphoto.net/uploads/965d7e9e63.jpg
According your postprocessor you must give real numbers of coordinate system or 1, 2,.. (if postprocessor make operation...