Hello Kenzo
Exactly the same on my Hermle. All soft keys are in English but the Cycl. Dialog are in German.
According to Hermle that cannot be changed. But I don’t think that’s too bad-...
Type: Posts; User: Bender {MMO}
Hello Kenzo
Exactly the same on my Hermle. All soft keys are in English but the Cycl. Dialog are in German.
According to Hermle that cannot be changed. But I don’t think that’s too bad-...
Hello experts :)
I want that the TNC chamfers the corners of a chamfer that was created with CHF. When I program like that
L Y+20
RND 0.2
L CHF 10
RND 0.2
L X+20
Then the machine says...
Hello
I am still quite new to this area so I have several questions: So far I “caped” almost all my parts (is that the right expression for that?) So I take the material about 5 higher than it...
Hello Gerd
It’s meant for aluminium and I believe it should mill a 2-3mm deep radial groove. I thought maybe there are suppliers that stock them. I could not find anything so I thought about...
Hello everyone
Where can I buy a 2,2mm VHM cutter? Coated, uncoated,2,3....9 the blade doesn’t matter at this stage.
Regards Manuel
I have had the problem before that when I use Q108 for the calculation ( also if I then allocate it to a different parameter e.g. Q108=Q10) that the TNC gave me an error message. The manual also...
Hello Hapo
If I understood you correctly then you simply want to read out the tool radius with FN18: SYSREAD Qx (x is the number that you want to use for the calculation of the overlap) ID50 NR2...
Good morning
I would also use a new and very sharp special plastic cutter ( key word mirror-finish) If the chips are sticky then I can imagine that the cutter creates too much heat so I would try...
Hello guys
The hard disk of our machine is already 15 years old and it probably has some errors already. Therefore we would like to exchange it ....
Where exactly is the HDD build in? Do I have to...
Hi snake
I recently created a simple program for that. You can also change it so that you can call it with PGM call. I don’t that at the moment as I am just too lazy ... smile.gif
In the first...
Hello
When you press the combination Ctrl + Alt+4 on the computer at the programming station, then you get to the “program save/edit” mode. There you press Ctrl + Alt+P and you get to the PGM...
When the door is open then automatically all axes are locked. As far as I know, they can only be unlocked by closing the door.
Why don’t you just use a tool changer? Simply enter L=0 into the tool...
Hello cgTNC
That is the only display of the grooves. Only one cut is displayed that shows the depth and the thread.
Do you think it’s hard to program then?
Hello everybody
Two days ago I had to mill an exposure into a aluminium plate. Unfortunately I didn’t have many measurements. I tried it with FH but (in my view) it failed due to the lack of...
Spontaneously, I can only think of a 2-3mm thick perspex that one can somehow place on the inside of the glass. I guess it will go ‚blind‘ very soon but costs only a fraction of a safety shield....
Good evening everybody
As I am not working very long on my Hermle , I am going to have a few question in the next time. smile.gif
This one is probably an easy question for you:
I have a normal...
Hello you have to copy the program in the programming station onto a differ part of the hard drive as word ( as you found out already) can’t work with the files from the TNC folder.
It doesn’t...