This is going to be messy...
Type: Posts; User: 2002maniac
This is going to be messy...
Looks nice! You'll have lots of people interested, but few will be willing to shell out the bucks that must cost to build.
I've got a Tree J325 that has not run coolant in years. The sump was emptied way back when but now appears to be overflowing with tramp oil. I can't seem to find any drain plug. Do I need to pump...
HSM express is very powerful and FREE! Although it is only 2.5d it really is an awesome package.
demo or full license? demo mode does not post.
Sounds like it could be an issue with your solid model. What file type is it? I've seen some solid models with line segments put together to create arcs. Talk about a lot of code!
Not worth it. If finish is important at all, the stepover required will end up taking much more time than another setup would.
if you want to input feedrates in in/rev you will need a G95 in the same line as the G84. Throw in a G94 when you're done. Or just calculate in/min FR as stated.
It could be caused by the CAM if the post adding a G09 top the code.
Check for that.
Which package were you able to haggle down to $200? Is this the V21 Express hobby version? If it was V25 I'm all ears :). It's much easier to deal with sales buys when you know what their bottom...
I backed out the adjustment screw 3 turns and it did reduce the amount of spilled oil, but was still puddling. I put a switch on the power wire for the oil pump and turn it off whenever the machine...
Lots of good info in here!
been using Vactra 2 this whole time.
I think the oiler is delivering too much and I think it's getting worse. Now I get a few silver dollar sized puddles after running the machine for just a few hours. The oil is dripping right off...
No, the machine is usually off overnight. The puddle is on the ground directly in front of the table. It seems to be dripping from the front of the Y way. I'll look for a cracked/broken line.
Anyone dealt with a similar problem? I'm having to clean up a small puddle of oil every morning and have to fill up the way lube weekly. This machine is only run for a few hours a day at most. ...
Is there any way to increase the feed while cutting air? Seems like that is the only downfall of this technique.
Thanks!
TM1 in the settings turns rapid override on.
Hi guys!
I've got a tree 325 with the delta20 controller and while chasing a RS232 problem back to a board in the cabinet, my electrician pulled the board to check for bad contacts. When he put...
Seems like everyone has their own "Secret recipe" as far as the wiring goes. I'm going to keep trying them one by one until i get one that works :)
For now I am able to send to the controller,...