Search:

I believe it comes on when you press the on button. Then when you press the reset button it clears and spindle starts.

Yes it does

How comes the spindle on button on Mach 3 software does not turn on he spindle? If the reset button is pressed after the Spindle on then it turns on. Is it because the control logic is inverted? How...

I am getting a g code error. Radius to end of arc differs from radius to start. What can I do? Is there a setting I can increase. r1=1.3046 r2=1.3039. I am using Cam Export to generate the gcode.
...

I am getting a g code error. Radius to end of arc differs from radius to start. What can I do? Is there a setting I can increase.

Jamy

I figured out what was missing after my last email. I didnt have
addf and2.1 servo-thread. I think I am going to add buttons on the screen for auto and manual then I can remove the halui.mode.auto...

ok, I entered the script and corrected the errors. But it does not and the two signals. I checked the hal meter for the two inputs and they are true but the output is not. Here is the script. Do I...

I sort of understand.
So if I put this in the hal file it should work?

net RemoteStart and 2.0.in.0 <= paraport0.pin-15-in
net OktoRun and2.0.in.1 <= halui.program.idle
net Run...

As of now there is only one input. That input is used to start a program. When a M0 is called in a program it pauses the program. I want the same input switch to resume the program.

Is that exactly how I would type it into Hal? Im trying to find a good resourse on hal and halui online where I can learn the proper way on doing things like this.

Yes I know the S will work and also clicking on the resume button on the screen. What I am refering to is a button used by a operator to start a program. I would like to use the same button to resume...

How do I create an input to start a program in EMC2. Also the same input to run the program after a M0 stop command. I was able to do start the program and when it got to M0 it stopped but when I...

DOEs G98 G81 work on EMC2 Software? G98 does the rapid move to R.

How do you know what max velocity and acceleration should be set in the configuration for a stepper motor? Also is there a Drill g-code that Z down fast till a certain height then slows down through...

How do I go about doing the M64 and M65 turning on the Digital output. I know in the program I just type M64. But in the HAL file?

This is whats in the manual.

12.12 M100 to M199 User Defined Commands
To invoke a user-defined command, program M- P- Q- where P- and Q- are both optional. The
external program “Mnnn” in the...

I am trying to create a M100 to turn an output on in a program. What is the descripter for M100 to be used in HAL. When I create a Gcode program and open it it causes and error because M100 is not...