Toppers! En gang ska jeg og bygge meg en svær maskin... Fantastisk jobb.
Type: Posts; User: StarkJohan
Toppers! En gang ska jeg og bygge meg en svær maskin... Fantastisk jobb.
dharmic: Is this the kind of toe clamps you're using?
Foot Toe Shaped Cable Clamp Toothbrush Holder Phone Pen Mount Stand | eBay
( Sorry, it was the first hit on eBay for toe clamps ;) )
Hvordan går det med prosjektet?
By the way, both power switches are illuminated, the illumination just isn't wired up for some reason...
Yep. I just thought I might need a bit more control throughout the whole range as the voltage and RPM isn't truly linear.
The problem is that the VFD outputs 12VDC (actually 13VDC) to the...
Ok, I think I read something about the 0-12V issue somewhere. I have a bunch of micro controllers lying around so I'll give it a poke with my scope and if I can locate and confirm the issue it should...
I recently discovered that the RPM set in Mach3 does not correspond to the true RPM. I emailed Omio but it has been a few days without any answer. Tried tinkering with pulley settings to no avail.
...
When I installed the motors I tightened the bolts as much as I could by hand. My Z axis was accurate but rather noisy with a kind of grinding sound to it. After tinkering a bit I found out that...
Finns det noen norsk sajt som selger gravyrplast? Sliter med å finne noe lokalt og jeg har ikke bil.
Hvis ikke i Norge, hvor kan jeg kjøpe fra utlandet til en rimelig pris?
I just received my X6-2200 last week. Bank transfer worked fine. Customs value was set to USD750. I received the machine within one week of payment. Delivered at my door here in Stavanger. I am yet...
zeeflyboy : Where did you source the 4 pin panel mount female and 4-pin male plug for the VFD? From the picture I can't tell if it matches the motor cables or if you just did an odd one. Also, did...
Yeah, I ordered new tubing right away. Linked straws would be better than the original tubes...or macaroni. 5 meters PU tube was $13 shipped from our Chinese friends.
I'll have to check the...
Yep. Everything worked out great once I got the uncorrupted settings file in use. It had only partially been imported as it was corrupted for some reason.
Today I've routed the first test patterns...
My machine arrived earlier today and I have it set up except for the spindle. It was moving a bit slow out of the box but after calibrating "steps per unit" in the settings tab I get satisfying rapid...
Yep, got all the info i needed barely an hour later. Your experience with customer support is one of the reasons I went with Omio even though their price point is significantly higher than other...
Email sent. So far they've been rather helpful so let's hope for the best.
I ordered the X6-2200L yesterday and I'm setting up a Win7 machine to run Mach3 while I'm waiting for the big toy to arrive. I understand that I will receive some drivers/configs from Omio at some...