hello
sorry for later reponse
please explaind your problem
hard disk is ok ??
220 model is a same with 120 D ??
when you connect your hard drive to your pc have you 4 partitions ??
Type: Posts; User: steph06
hello
sorry for later reponse
please explaind your problem
hard disk is ok ??
220 model is a same with 120 D ??
when you connect your hard drive to your pc have you 4 partitions ??
cool
i'm happy for you !!
bye
hello puggy
folder CU91 from working image at this link
CNCzone.com-The Largest Machinist Community on the net! Over 300,000 members and growing.
good luck
don(t forget
make scandisk on your...
if it possible yes i help you
what problems have you excatly ??
models ?
hardware ?
trooble ?
hello
what is exactly your problem ??
agiematic CF boot on your hard drive ??
what message have you ??
regards
hello
success !!
my fake agie hard disk running
agie 120 start with my 260 Mo hard drive with ghost image
hello
success !!
my fake agie hard disk running
agie 120 start with my 260 Mo hard drive with ghost image
sorry bad thread
hello Sif369
please read your private message
thank
regards
no other people have problem with agie hard drive ??
hello
no solution at this time
i start agie with an 260 mo hdd
but i'm blocking at this stage:
checking security device
i don't no if it is software protection or other problem
i go to make...
hello
i progress to repair my hard drive
but have you a solution for this stage
checking security device ...
hard drive stop here
any solution ??
make a good day
hello all
have you a solution for reinstall hard disk on agie 120
ghost image or disquette installation ??
my hard disk is dead
i have any idea for rebuild data and i found nothing on the web...
the board is out of the drive no power needed
yes the test point are for oscilloscope (checking base drivers waveforms)
i haven't oscillo but some idea :rainfro:
regards
stephane
hello
i'm happy for you
one question
where you find DK434 ??
have you an adress for me because i don't find hybrid here !!
thanks a lot
regards
stephane
hello
some news
i have repair my SEIO1 cards
and all is ok now
3 DK434 was dead with transistor(c2939)
ch50 an 53 (phase R)>converter
and (why ?) ch49 >inverter
for test ch44 to 55
hello
i'm happy for you
for me bad new
spindle don't start
error IOC
transistors ok
"rebuild ch50" on se-i01
some ideas ??
bye
hello
i repeat
check SE-IO1 card before power on !!
bye
hello
check powers transistors and SE-IO1
i have same problems at this times
i have change powers transistors(2DI75D-050)
and i wait for repair channel 50 on SE-IO1
bye
hello
thank for answer
it' ok for meau site just IE scripting disabled
for DZ20 > zener diode 3.6V 1.3 W
D44 > 1N4007
for 2SC2939 or 2SC4058 equivalent BUW13A or NTE 2311
i wait for...
hello
i'm stephane from Nice(france)
i have mazak QT15 with FR SE 2 22K A-C spindle drive
i have problems with SE-I01 card
burn on CH50
have you value for DZ20 and D44 ? on CH50 line