Search:

Hi we have had a 1996 sabre 1000 for about a year and I still cant work out how to turn the work light on I know the globe is good anyone point me in the right direction

Ok thanks Mike

would anyone have a Z axis way cover for a sabre 1000 they want to sell

Anyone know what this red speaker is that comes up on the screen of our sabre 1000 2100 now and then doent seem to effect anything

Hi Mike turns out was a fault with the vfs5 Mike Kilroys guys have fixed it

Thanks Mike for getting back to me turns out that the churp is the spindle motor restarting what seems to be happening when the spindle is running at say 3000 rpm it looses power and the gets power...

Anybody

Just when we thought we had this thing running good {sabre 1000} the spindle started to give a intermittent small squeal with a corresponding spike in the motor load indicator not all the time starts...

Thanks to mike and the guys at Mike Kilroy Corp for the help in getting our machine back up and running took awhile to work out the problems but all seems good now

Hi Mike this didnt work still the same I can move Z down with MDI G01 faster than the jog and no issues here are the 2 errors I get the over volts and under volts are on the Z axis only under volts...

Is it possible to get in and adjust the decel rate on the Z axis for the jog mode on the pendant this has been suggested to me to fix a Z axis problem I have if so how is it done thanks

here THE...

I did mention this

Thanks Mike do you know why I can send the Z in MDI G0 which is way faster than the jog on the pendant and not have an issue unless I slow feed with the pendant

http://www.cnczone.com/forums/attachment.php?attachmentid=316140&stc=1http://www.cnczone.com/forums/attachment.php?attachmentid=316138&stc=1 these are the 2 errors I get
Ok Mike 1 the ohms are 2.2
...

Hi Mike just had a quick look what wires are you saying to check heres a pic of the PSR I cant see them315740

ok so having a bit of a play with this if I send the Z axis down in MDI at full seed no problems only have an issue jogging with the pendant at 100% can jog at 60% without a problem

Ok when jogging the z in the neg at 100 % head drops by it self after about 6 or 7 inches of travel then the brake comes on if I jog the z in the neg at say 60 % of speed no problems

mike-Kilroy you can jog the machine down in the z it travels about 6-7 inches at 100 % feed then starts to run and the brake comes on aswell as the alarm but if I jog at say 60% of feed no problem...

thanks for getting back to me Mike the overvolts light is on on the z and a drive but we are not using the a drive and have a blank off plug in the a drive so I can jog down in the z but not at 100...

I have a problem when jogging the z axis if I move at 100% feed rate in the - it travels about 6 inches and starts to run and the brake comes on and I get this message checked the driver and the...