Search:

CNC Router Table and Accessories for sale (Melbourne)


You may have seen this CNC Router Table being built quite a long time ago and with the help of quite few users through this site. I had to...

Unfortunately, I have moved into a lifestyle village now and there was no possibility that I could move in with a router table and the associated noise so I had to sell it some time ago. I was just...

Grab one, they are good :)

I would not be without one now... make sure it is Ver 2

Sounds like fun, not :)

Hope you are handling the all water well, that is one place I would not want to be during the wet.

Hi Kat,

Remembering that my drawing is done with one hand, I'll try to explain how I achieved the screw mounting :) with the help of another CNCzone member.

All the machining at the driven end...

Lookin' good so far :)

You will be fine, she's an understanding wife (chair)

Good to see some work is still being done :)

Hi All,

I ordered a step and direction indicator from CandCNC a few weeks ago to put some fancy LED's on my step and direction signals. It is not working yet (still building it) but the thing has...

Very nicely done ;)

How was the ozito router mounted, we usually remove it totally from the frame and then just make an alloy clamp for it.

Hi Albert,

Good to hear that you are starting a build again..

Can't offer much help but mine is all alloy and only 900mm X 600mm cutting area. Linear bearings and rails would be better bought...

Hi,

Very nice build :D

G'day Leon,

Edit: Just read it again and it is coolant :( my answer is no good :(

Ripper!!!

Bet that gives you some satisfaction :)

I'm still designing the case for the G251's at this stage, no rush because mine is still working :)

Hi John,

I am at Hoppers Crossing near Werribee if thats any good :)

Did you have any luck with the lube and wash?

For anyone looking for 2.8k in Australia, have a look at Radio Spares...

Hi Mark,

That is the one, thank you :p I can mount it on it's case now.

How do you remove the big red button, do you just give it a real good shove to get it off?

E-Stop is as supplied by Kelinginc.net

Yep, I will wire them individually :)

I'll check that out when I get closer to the wiring of switches etc!

Well just about have the circuit diagrams done now..

If you spot any errors, please let me know!!

I have used ITEM which is similar to 8020 and if you are using large runs I would go for the thicker profiles. I think they have thickness calculator somewhere and that should remove all the guess...

What is the problem with the Z axis?

The piccy's look pretty good :)

Hi Russell,

Yep, I have got plenty of time.... Slowly goes it!

I got to get the case sorted first and lots of little bits, all good fun :banana:

Hi,

Well I am still around the place and I am about to upgrade the router with new steppers, drivers, power supplies, e-stop, cabling etc!

So far I have got the following from Kelinginc:
...

Yep, I know where it's at.. I'm a Benalla boy originally :)

I would use the last one and exactly as shown in the diagram, the curve makes the nut sit in exactly the centre of the 8020 and it means that your rails will be centred.

Thats what I have used and...

Hi Diarmaid,

Best of luck, and I mean that :) hope this time he means it!!!

Looks good Heath :)

It has nearly been a week and they are still celebrating :)

Which part of Melbourne are you in?

How is the construction going? any pictures?

I am still waiting for a BOB so it will be a while yet.....

Good to see that it's all well now :)