Search:

Sorry to crash this forum but i have begun getting emails from tapatalk ( example sexy.web has started following you).
I tried the support form but it wont go thru saying you have made too many...

I am unsure so can't really comment but imagine it is a liability to NOT have it in case something happened. If you are running a business I would say go the legal route why ask for problems down the...

Regarding electrical. If for home use no real issues. I use mine in a factory setting and safety rules there say all eqpt must be CSA compliant. Studica did do electrical changes to comply and...

check this out, HF 97009 Bandsaw regularly 880, last week on sale 500 ( open box yadaya) yesterday still there 359, this morning stop and ask for the 20% coupon, manger says take it. 278 before tax....

Alright!!!!!!!!!!!!!! I have the 770, love it so far, amazing piece of equipment for the cost.

Pickled:
I like the "dragons slayed", how true that the stretch provides the growth.
Yes the current state of hands on isn't like it used to be. I did everything myself when young because I had...

All done, dovetails cut here,later the lead screw and QCTP hole done. Works great.
Learned a ton thanks to all for their comments. Cutting rates and times were way slower than I am sure some could...

Thanks Bryan, rougher was corncob type 30 degree helix. Finish EM variable flute. Today doing dovetails found the tool pulling out tightened drawbar quite a bit so maybe that was part of the problem.

Interesting day making my compound slide. First used 3/8 Lakeshore carbide 4Fl rougher, 2000 RPM 10 IPM, 0.1 DOC, 0.25 WOC to cut a pocket 2x8X0.375, tool ran well no chatter, finish was adequate.
...

Travelling all week so just catching up on the posts.
Next week I will put to use some of the suggestions. Thanks to all who commented, hope to have some good reports next week on the attached!!

Thanks all for the comments. I believe that I probably made several mistakes.

Belt was on high RPM could have gained some torque using lower pulley, maybe when machining steel just always use the...

Hello all, newbie here just starting out with cnc.
I have had my 770 for a few months and today was cutting a L00 lathe chuck wrench from 1/4 1018 CR plate.

Using G Wizard I set up 3/8 4 flute...