Nice very nice
Type: Posts; User: marcel beaudry
Nice very nice
Hello does any one as electrical plans for the nm-135 novakon milling
Thank you for your time
Marcel Beaudry
Very nice
Good Job
Marcel
Try Newman tools
Same here
Marcel Beaudry
Bonjour Joe
Belles machines
Marcel Beaudry
Hello
To hold the ball while machining the last face,put masking tape on four continuous machined faces and pour epoxy glue , to remove put cube in a glass of water and put in a microwave to soften...
Hello
I have asked that question before with no answer from novakon
so what i do is put a m00 after the line where the speed is indicated and wait for the spindle comes to it full speed if it...
Hello David
My collet is 4 inches long
the toolholder as a recess that should be bigger than the collet.
Marcel
David
Do you have a regular collet or one that has been modified .
The one that i have is shorter than regular collets
Marcel Beaudry
hello Sculptorr
Very nice model
Thank you
Marcel Beaudry
Hello
Yes it could be done on a nm-135,the well for the magazine as to be done by another means as the sides are square . i would use a mist system because it uses much less coolant and blows the...
Hello Eric
I have the nm 135 ,
It all depends on what size table you need and what speed your end mill will turn.
speed is good if you want to control your tool on a small machine if you cut...
Hello
The NOVAKON nm135 as taper gibs
Marcel Beaudry
Hello Jerry
What i did for this part is i put one piece of mdf in my vice then put double sided tape on it then stuck the thin sheet of brass on it . the sheet was premarked with the center of the...
Hello
Also you need torque at slow speed the nm135 does not have any torque i do not know why it is supposed to have 1.5 hp .
Marcel
Hello
Do not know the brand it came with a machine made in japan
Marcel
Hello
double sided tape
Marcel
Hello
Small part i made with my milling
the webs are .010 wide the rim is .015
lot of fun
Marcel
Hello fourwheeler
Are you still in need of an of an xml i can send you mine.
Marcel
Dear Sir
It all depends on the kind of locktite used some are removable others you have to heat the threads with a soldering iron to break the bond
Marcel Beaudry
Hello
I bought a NOVAKON NM-135 , great machine i like the speed 6000 rpm ,precision how about .0002 would not part with it .
At the beginning had small problems with it but Khai solved them...
Hello Travis
A small collet , it will have to be a small fly cutter i do not know if your machine as enough power for a large fly cutter.
Marcel
K A R catalog page a168
Marcel Beaudry
Bonjour
Pouvez vous expliquer quel est votre probleme
Marcel Beaudry
Beauport
Hello
For me there are creators , artist ,and artist creator .
An artist can make a scupture of a cat (for example)
A creator will give it life , or a moment of (why did i not think of...
Hello
how about a T nut slot cleaner
Marcel Beaudry
Hello
Yes the trick is small cuts high speed with a mist coolant or cold air from exair
Marcel
Well i tried mine with mach 3 wizzards and it came to +or- .0005 in wood and fortal aluminium very nice
Marcel Beaudry
Beauport Quebec