Search:

Update.... I love warranties. I plugged the wires from the stepper motor directly to the controller and had the same results. At about the same time Tim from CNCshark was very helpful and told me to...

The search continue. I took the advice of Jeff "Assuming all the steppers are the same, try swapping the z stepper for the y." I found that all the stepper motors faltered on the 'Y' connection from...

Ok. I started by using your suggestion. I set up a new 0,0,0 and jogged around the table and then had it go to 0,0,0. It was way off (some of the times). I realized a few things.
1) It was the Y...

thanks Danny-

I will give it a try and let you know how it goes. I really appreciate it!!

chris

I have a new one. My router (cncshark) isn't following the gcode on the screen (from vcarve). I'm just cutting a circle and some stars.The numbers I'm reading are correct but the router is way off...

Wayne-

I've been gone for a while but thanks for answering my question.

I loved your quote "It's like making a cow out of hamburger".

wayne wrote "It is possible to create a point cloud...

here is the link to conversion image

http://www.flickr.com/photos/34396447@N06/

WAYNE-

Here is what the dxf looks like from gcode to autocad to rhino. The dxf can be seen but it is a series of 1448 curve segments. I tried to join them but had no luck. Take a look and let me...

wayne-

I went in MOI. I didn't know what to look for so I tried to make the cuves into a network but it didn't do anything. I know that Rhino looks at each segment as its own curve but I don't...

Wayne..

All I can say is thank you. I have been making some designs in vcarve and cut3d but I can't save them as models. your app really helps. But... now what? Do you have any links on good...