Did you get any advice?? I currently in the same boat..
Type: Posts; User: totalfab06
Did you get any advice?? I currently in the same boat..
Thanks.. I did get through and pointed in right direction. I do have a bad motor and will need to replace it.
Tried to boot machine today and it wouldn't home the Z drive. How can I tell if its the motor or controller??
I also would not consider anything but a Hypertherm. I have a 1250 that I have ran for 3 years without a hitch.
I guess nobody else knows how to do this either.
I use We-Cim to mark the hole for piercing. I would also like to know how to do this in auto-cad . I don't know if you can modify the .dwg with Sheetcam to Peirce only. I'm sure there is a way, it's...
Try Plasma Quench http://www.koalindustries.com/plasmaquench.html This is what I use in my table. I think it cost $250 for what I needed.
I have used this software for about 1.5 years. It is good software for the nesting and material tracking. I've had better luck with CorelDraw with the raster to vector convertion. The people at...
I always use http://www.hypermax.org/index.html They have the best prices that I've found. The shipping is prompt.
I use WE-CIM. This is a very user freindly program. The customer service is top notch. They will work with you to customize the program to best suit your needs. I bought the software package thru...
Plasma Quench is what I use. I have not had any problems so far. http://www.koalindustries.com/plasmaquench.html
I cut perf. all the time. I just use about the same settings that I use for the same gauge solid. I cut 22 to 16 Ga. perf. with no problems stainless and galv. I still use the THC.
You need to keep the drive side as "true" as possable. The slave side is a little more forgiving.
I haven't posted in a while. I got the replacement table built. I took the dimensions from Dynatorch's drop side table and modified to fit a water table. This has solved all problems I had with the...
How could I get the original file from Thermal dynamics?
I have had my table up and running for about 7 months. I too bought the we-cim software. The software is great. The class is a must!! Gary and the people over at Wittlock are top notch. They will go...
I
I got the problem solved. I hope! The table came with the master side gear rack about .375 out. The gantrey would jump off of the v-rail. I couldn't tell from slave side of table. I trued redrilled...
I've imported dwg, nested it but can't convert to code. I don't know if I'm just dumb or what?
I am going to Daynatorch for We-Cim training the end of June. How do you import from We-Cim to burn?
I finaly got the table running. I used Plasma Mate to draw a segmented Donut. The outside dia. was 94.5 but ended up 94.937. the inside dia was 71.86 but ended up 72.6. It was segmented into 60 Deg....
I'm new at this.. I have purchased a Hypertherm 1250 and a 60x120 CNC table to do some work from the house. I want to know the best filter set up for the plasma? I'm getting a 3 in 1 dryer later. Any...