Search:

Looks like someone solved to my question :)

Hello,
This Mach 2010 looks pretty good.
Do it works with chinese xhc mk4 ethernet board?
Regards

Hello everybody,

i think I fixed the issue.
After many tries, read a lot of topics,I didn’t find anything then,
I disabled the output into GeneralConfig->port and pins-> outputs.
i started the...

Hello everybody,

I noticed that I can reproduce this stall by just activated/desactivated e-stop button.
I can run a lot of times without any problem but when I hit e-stop button and run GotoZero...

Hello CitizenOfDreams.

It happens only on the first move after I start Mach3 or after a moment of inactivity but just for the Gotozero button.

I had same problem for the auto tool zero button...

Hello and thank you for your concern


When the motor stalls, it do not hit the mechanical stop which are inductive switch, it just stop by itself


I have set up the Safe Z move at 10mm.
I do...

Hello everybody

When I am running GoTo Zero command just after starting mach3, the Z engine blocks and then finishes the sequence but the positioning is wrong. If I restart the command just after,...

I have the same card as you.
Have you been able to find a solution to your problem?

With the driver v2.39.9, the problem is always the same for slave axis.
My gantry is moving well but my slave...

Hello

I have the same card mkx-IV driver v2.39.9 and mach3.
Have you been able to solve your problem?

I have a switch on each motor of my axis (Y & A).
Axis A is slave to the Y axis.
When I...