Search:

Hi,

I have an ACR8000. I have not used it or test it but it comes with all manuals and software from the factory. I can give you more info if you need. I started out collecting hadware for a...

It happened to me. The sent out fake e-mails stating that your account has needs to be verified. It looks real enough. I put in my ID and password, though everything was fine. They used my e-bay...

It might be easier if I broke it up into three parts, for three simple molds. Here are the outer, inner, and turbine(fin) portions. I think the other mold would have been too labor intensive. I...

Here is the Parasolid zipped up. You will have to add for shrinkage and machining. Let me know if any changes need to be made to the model. Thanks,
Kerry

What type of file would you like? IGES? Parasolid? ect. I will send it as soon as I can. The part is approx. 1.5" x 4.2" x 2.5". I also found the RFQwork.com site and have a few pictures there as...

I've been looking for the RFQ on this site but haven't been able to seem to find it. Or if anyone can show me the way to it... Must have moved during the last upgrade.
I'm currently looking for...

Great, thanks for all the info. The machine I'm looking at is from a cnc shop that is local and looking to use the revenue from the machine for a down payment on a high speed machine. It's still in...

Well, most of this sounds interesting(some over my head). My only worry is that I were to buy a machine, and then produce an item that will be laughed at when it comes to tolerances. Idealy I would...

Humm....I guess since I design in the "perfect world" of solid modeling, it's hard for me to actually "see" what is tight and what is not. Thanks for the info. Is there any particular test part...

Hi all,

My question is this-
What is considered good tolerance? I'm starting a part time shop and am looking for a used CNC machining center to start out with. I have been a designer for...

Al,

I looked at some of these a while back when I recieved the card. Not sure I know what to do with them yet. I figured as time went on, I'd find out from forums such as this.
The...

Al,

The Z axis will be that high. I'm thinking something like Aluminum, maybe 6" x 6" square tube with two rail slides on each side. Or maybe something from 80/20 if I can find it. Then use two...

Al,

Thanks for valuable info. I figured I would go bigger on the drives to make sure I don't "under power" the machine I am designing. I'm currently designing a 5 axis router (3 to start). It...

Al,
Thanks for the info. After looking into the manuals, I have a servo type card. Also, the installation of the driver a bit fuzzy concerning the encoder. The site for the driver (Omron...

Hi all,

I've got a few questions about some hardware installation. I've got an Acroloop 8000 controller card. I would like to use Omron R88D-UA20H drivers for my servos. It is a 200v single...