Search:

curvic coupling

or

hirth ring

We had a Vector drive that was failing for a while, and all of a sudden it took out 4 servo drives at once, Burned up components on all 4 drives. This was on a Haas 630 horizontal mill

I actually have 480 single phase if you count my step-up transformer that I use to run 480v input drives on the lathe and mill

Check your Private Messages (Notifications button at top of screen)

You need a follow rest that leads the tool and supports the material on the full diameter where you have not yet cut the taper, you may also need something to support the small end and keep it from...

Why not just connect a serial cable between the Dynapath and your PC, by far the most convenient way to transfer files and if the files are too big for the Dynapath memory, you can "Drip Feed" this...

The problem would be the battery on the motherboard, you have lost your "CMOS Settings" which identify your hard drive type, you must go into the CMOS Setup when booting (About the point you have the...

The options labeled "*" are installed on your machine, the rest must be purchased from Dynapath and they will mail you a floppy disc that will enable whichever additional options you purchase. (Read...

That is going to vary depending on your memory size options installed in your machine, Call Dynapath with your control serial number, they are very helpful and nice to deal with

DynaPath CNC...

It would probably be easier to mill with a slitting saw than a tiny endmill.

I have a good monitor out of a Delta 50 control, not sure if it would be the same as the Delta 20 but would make you a good deal on it if needed, it is a 9" Green CRT, runs on 12v I believe, I have...

I believe the distinguishing factor between the resolver and encoder is that the resolver uses an ac excitation signal (sin wave) and is basically a transformer, and the encoder would would not...

If you get the error Machine zero locked out by parameter When doing a (M) machine zero, in Jog mode
Then your mill probably has home switches and you would need to do e reference, here is the...

Yes, you will need to use a standard AT style keyboerd.

Yes, I do have an enable input on the drive so as long as I have the PDM signal on and at 50% for a 0v output before the drive enable is turned on that should work fine. I am not really trying to...

Newbie here,

Trying to create a servo system with the loop closed in EMC, I would like to know if PDM in EMC has the capability to give me my -10v to +10v signal to drive the servo drives using...