Dear all.
I have my trouble is: My CNC machine( it's using Fanuc OMC controller, with PMC axis control) can't run M-code from Memory mode, but I can let it run correctly in MDI mode.
Does any one...
Type: Posts; User: namnp2009
Dear all.
I have my trouble is: My CNC machine( it's using Fanuc OMC controller, with PMC axis control) can't run M-code from Memory mode, but I can let it run correctly in MDI mode.
Does any one...
Daer all.
I'm used Operator's Panel( A16B-1310-0380) board on Fanuc OMC system. I'm can run Test run OK, but I can not make it available inside PMC( all F292.0 - F299.7 is allways= 0 when I depress...
Dear all.
This problem was solved when I connecct both M1A and M2A wire( maybe the problem is the NC8 signal, locachted in MB2.50 pin).
Thanks for your attention. Please close this topic.
Nam.
Dear tc420
Could you share the software to me or may I can buy it from you?
Thanks.
Nam.
Dear all.
Now I need to built 5 axis CNC Milling machine, used Fanuc OM controller. Does any one know what's the hardware ang software I need to buy fist?
Thanks for your help.
Nam.
Dear Al_The_Man.
Now I have the same problem, could you sent me the trouble shooting procedure to my e-mail: ]. Thanks a lot.
Nam.
Do you have TC217 service manual?