How to reach world peace?
What machine do you have? The «normal» process if it hasn't been changed by the manufacturer, is to load the standard parameter file (load ->d4). There you'll find the...
Type: Posts; User: onkel-howdy
How to reach world peace?
What machine do you have? The «normal» process if it hasn't been changed by the manufacturer, is to load the standard parameter file (load ->d4). There you'll find the...
Sf100? What kind of motor is it?
Generally I would spend 80€ because it would be more expensive if you’d make it on your own in consideration of working time.
Internal port is defect… it happens in case of such veterans ;)
Exchange the card for a lot of money or find somebody who can repair it.
machine?
Controller?
Type?
Do you mean with subprograms?
Well, then always recharge your device. As I said, this could have had a lot of reasons.
Which regulators are inside? It’s an analog controller. It can have Siemens, Indramat, Bosch etc. inside.
What error occurs? Ticktack might be normal…
1) what controller is it?
2) what regulator?
3) the error occurs only when you turn on the spindle. It may be a cable, a sensor, loose contact, motor etc…
Do you have a device for measuring...
Hello
It has to be in the controller, doesn’t it?!
Or at least in the backup…
Isn’t the cutout more expensive than the whole machine? ;)
What controller do you have?
What machine?
What does the manufacture say?
What drives do you have?
In what connection?
Question upon question… reading tea leaves: your spindle regulator...
Is the exit for opening controlled?
What exactly is the problem? The cc200 series is as almost every bosch very similar to siemens in terms of nc program. There’re only cycle calls that are different.
Call to firm irco/breuning. They lend to their clients adjust optics at least. Also for clamping into jackscrew and messing…
What does the dmg service say?
One of your regulators doesn’t give any btb.
What controller do you have?
As far I know, until it’s overwritten.
What is it for?
Every machine manufacturer has such a program. In that way places are tested. Just start a program for 3 days and check whether all places are ok. But as every manufacturer has...
I mean it seriously -> what at the moment here is.
Baaaaaaad case ;)
Could I ask about the year of manufacture of the device?
It sounds archaic ;)
You don’t necessarily need 2 coat control cycles. There’s a splitter from Siemens that disconnects 2 measuring systems or brings 2 measuring systems to one coat control cycle.
One makes it for...
It’s generally possible. I’ve made it once, but with linear motors and a “modern” Siemens 840d.
What controller do you have? What transmitters and what gears?
Are you sure?
Maybe the plc doesn’t monitor it, but the axis or mandrel controller does. And if it receives no “speed reached” signal, it locks all feed axes. That way I would do it, and each...
1) default code number for heidenhain is 807667 (access to everything). What the manufacturer makes with it is variable. Possible that it works at deckle, but not at hermie…
2) that’s right, with...
I don’t understand why you had to reinstall the parameters after blower changing…
But about your problem:
PLC programs are usually archived in the machine code in the backup. So usually you won’t...
1) try to play with mp1407 and 1409. P and I parts of axial controller.
2) if I’m not mistaken, there’s a machine parameter where you can regulate the start advance.