Hello
You have to interpret that message as a little warning sign.
Some controller (e.g. Fanuc) sometimes can’t run very small G1 movements which causes a machine stop. Short G1 movements are...
Type: Posts; User: RCCS
Hello
You have to interpret that message as a little warning sign.
Some controller (e.g. Fanuc) sometimes can’t run very small G1 movements which causes a machine stop. Short G1 movements are...
Hello Andreas
I have changed the value. It was set to 0,2.
I have done a PP run and no error came up anymore.
I will have a look tomorrow if it also works on the machine.thumbs-up.gif
...
Hello Gunter!
I have exactly this configuration and it works better than XP 32bit&64bit!
Greetings
Andreas
You’re welcome
Have fun with hM :)
Greetings
Andreas
Hello!
When does the error occur?
If it’s an error of cycles, then try to drop the first job with pressed shift-key. It’s a kind of security by OM. Then one job has to stand under Linking-Job....
The spindle is inside of a Deckel Maho 600W.
But it’s without the 18-stepped gearing
Regards, Andreas
Hello!
What could be reason of the fact that our spindle gets stuck after an hour with retracting 100r/min after spindle service (remounting)? Did the technician cause that?
Thanks
Greetings...