Search:

I could sure use a copy!

Program number should be o not a zero followed by 4 numbers. o0015

Fanuc System P Model G I ran across one of these and it peeked my interest. When I power it up it says Fanuc but that’s all it does. Do you need software to make it do anything. What is it used for?

You can change parameter 933.1 This will turn off the 4th axis and the machine won't look for it. I would like to do mine with a jumper like John B talked about. The manual isn't very clear on how...

Any way you put the encoder on the input shaft of the rotary table instead of on the motor?

When I remove the cables to my 4th axis I get a error message that says servo missing. I have seen on some machines a switch to override this message. Can this be added to a OMD control? The rotary...

Sounds right. Its been over a year and I sold the machine so I can't verify. I have a suspicion a change in the software was required to change the line count.

Thats the one I had trouble with. Rick at Anilam couldn't even figure out how to change it and he designed the contol. I would enter the pass word. It would allow me to change the number and I would...

I added a 4th axis to a gxm some time back. I ran into trouble with the encoder count. Had to use a 90 to 1 table with a 1000 line encoder to get it work. Even the guys at anilam couldn"t figure out...

Control is an OMD. How does a G92 affect this?

At the end of my programs my post calls for a G28 A0. This returns my rotary table to 0 but my screen reads 360. When I restart the program the rotary table goes all the way around and reads 0. Isn't...