Yes it does, I can travel fron end to end on Y with the handwheel with no problem and appears to be reading fine, i can tell when I jog slowly in both directions and also looks like counting ok in...
Type: Posts; User: XXcammasterXX
Yes it does, I can travel fron end to end on Y with the handwheel with no problem and appears to be reading fine, i can tell when I jog slowly in both directions and also looks like counting ok in...
No, we can't move the table by hand, when we calibrating the machine,
it gives me the servo fault anywhere right after start going home on Y, and
it tries to go too fast on Y. And yes...
when i turn the machine on and calibrate it i keep gettin a error message sayin axis not calibrated servo fault on y depres manual mode power reset servos and start and when i do this the same thing...
thanks automizer... but I checked that page and the one I am looking for is a old model of this indexer I don't know exactly how old it is. but I have this picture of it ... hope you or somebody can...
I have a Haas S5C indexer that i recently adquired. I want to know if somebody knows where i can get an operators manual for this. Or if somebody is willing so sell a copy for a few bucks.
Thanks ... I'll try and check every posibility you mention....
I have a Hurco KM3P mill. I need some help solving a problem I have with the spindle. When I start the spindle it always goes to the highest rpm (4000), even if you program a different rpm on the...