Search:

Hello

You mean G64 or? G54 is the zero point.

So it’s CFIN and G64 active. Even though CFIN doesn’t work in this case as the radius correction is not active.

Maybe I should add that it’s...

Hello

We immerse circular with 3 axis into the part (X,Y,Z) Our Cam doesn’t give out a circle but many single blocks with points. Now it happens that the machine doesn’t run with full feed when...

Hello

On our machines, the clocks all say a different time.
Is there a possibility to automate the synchronisation with a different computer?

Regards

Hello
I think there is a mistake
try
R3=$AC_TIMER[1]

Instead off
R3=$AC_TIMER[1]=-1

Now the time (in seconds) should get displayed in R3

Hello
In general you can also add DC beforehand then the machine always chooses the shorter way.
So when that is desired just leave it out.
C= DC(356) A1..
C= DC(359) A1...
C= DC(1) A1..
C=...

Hello,


The parameters for the current programmed feedrate is $ P_f.

e.g.

R1 = $ P_f

now the feed should be stored in R1.

Hello

I have the following problem and I hope that somebody will be able to help me out!
We have machines that are connected to a so-called pallet rack and we define the neutral points at the...

Hey guys!
It says it like that in the programming description cycles chapter 1 from Siemens.
However I never tested it myself.

Hello
It’s possible to solve it with R parameter e.g.:


R1=20 R2=0 R3=5 R4=-30
MCALL CYCLE82(R1,R2,R3,R4,,)
X20 Y20
X60 Y18
X80 Y22
MCALL

Hello
Maybe you could show us an extract of your NC text where the processing is once horizontal and once vertical. Then we can help you a bit better!

Hello,

did anybody here participate the following workshop?

http://sitrain.automation.siemens.com/DE/s...ourseID=1001741

Is it recommendable ?
What about the Siemens workshops qualitiy...