Reviving an old reply to an even older question, but I know this issue keeps coming up and I just stumbled onto the thread.
This error is generally caused by parameter 59 set to something other...
Type: Posts; User: nephroneis
Reviving an old reply to an even older question, but I know this issue keeps coming up and I just stumbled onto the thread.
This error is generally caused by parameter 59 set to something other...
I can probably help you with your file needs as well. Or if you're too frustrated, I am always in the market for used Multicams. Particularly if it's an MG or 5000 series.
Here you go.
266104
266106
Another one just for fun.
264778
264776
264780
Here's a dxf I made for one of the guys at work. We haven't had a chance to cut it yet, but I'll post photos when we do.
264674
264676
Pretty sure you meant:
264422
264424
But here's this one anyway:
264428
264430
Probably have a reaper and a few more skulls somewhere, but am in a rush at the moment. I'll dig through my files a bit more later. The skeleton3d file has not yet been properly joined, but should be...
Nothing spectacular, but here's one.
264312
264314
I'm not familiar with the prolight specifically, but the vast majority of cnc equipment finds the home position when limit or proximity switches are triggered. Odds are you have a bad limit switch...
Try reducing your speed on the curved cuts and see if the problem goes away. It could be whip in the axis movements.
You're looking at about a 20 second cycle time per piece on a turret punch plus a couple of minutes each to knock off the tabs and package. I haven't nested these yet to figure the material...
Hello all. I've lurked these forums for quite some time and finally decided to (hopefully) get more actively involved and contribute. I am the plant manager for one of Architectural Systems three...