Search:

This machine found a new home.

Sent from my LGLS740 using Tapatalk

Free to a good home.
Listed on craigslist at https://york.craigslist.org/hvo/5390209162.html305774



Sent from my LGLS740 using Tapatalk

Try looking at allied on Msc they've got some long bodies listed. someone put the wrong number on the order and we received a T-A 1 that was about 16" long. If you call a rep. They can They can get...

Does this machine also require an air supply to blast the taper during tool change? Or possibly for positive air pressure inside the bearings to keep debris out.
I would be positive that a manual...

Find someone with a swiss cnc lathe.

Sent from my LGLS740 using Xparent BlueTapatalk 2

Checkout sdp-si.com(stock drive products) they have a good selection,
or macmaster-carr I've bought pinion stock from them before.

Sent from my MOTWX435KT using Xparent BlueTapatalk 2

Isnt G71 a canned roughing cycle for lathes?

Sent from my MOTWX435KT using Xparent BlueTapatalk 2

Plastic tends to curl as material is removed.
What flatness do you require?

Sent from my MOTWX435KT using Xparent BlueTapatalk 2

Your feed is too fast. Your bit is bouncing around the bore like the piston of a wankel rotary engine.but in reverse since your conventional milling try a feed of 1-2 ipm. Try using G3.

Sent from...

Your feedrate requires a decimal. And no feedrate at g1 line.

Sent from my MOTWX435KT using Xparent BlueTapatalk 2

IMO its similar to choosing a threading insert. To keep in mind that the thread form doesnt have an exact point. This is more noticable on larger threads. If you cut a fine thread with a coarse...

Make sure your chips are getting away from the tool. Even if they are larger they can get stuck in flutes and "galling" the tool. This is when the previuosly removed material coates the cutting edge...

Ive, done this a couple times before. I would use the same setup as bobcad guy. Ive never used bobcad i used gibbs or mastercam lathe. The only issue would be the lathe posts the x axis in diameter...

Hello, I'm requesting quotes from someone to make these parts on a cnc lathe. I would like them to be made from cold roll steel. tolerance is +/- .03 on two place, and +/-.01 on three place...