Hello
I have a chineese CNC router with a clone rich auto DSP since 2012( when i bought the machine I was a total newbie and had no idea that there were original and clone parts), it was working...
Type: Posts; User: ecoworld
Hello
I have a chineese CNC router with a clone rich auto DSP since 2012( when i bought the machine I was a total newbie and had no idea that there were original and clone parts), it was working...
Hello
I am running into a similar issue. would very much appreciate if you could share your setting to overcome this issue.
Thanks
Hello
I have just acquired a mix co2 laser with Ruida Live focus system and Ruida RDC 6332M controller and have 2 issues with it. Would appreciate sone guidance to resolve these 2 problem.
Issue...
hello
Have you been able to find solution to your problem. I have just acquired a mix co2 laser and my problem is it starts cutting cutting after about 2 cm from the starting point even though the...
Hello,
anybody using mixed co2 laser machine with ruida live focus system. I am not getting the correct capacitance calibration for the live focus to work properly.
If anybody out there have...
Hello Dhei
Thank you for your reply.I am located in Mauritius. would very much appreciate if you send me some photographs. My step motors have four wires and the circuit diagram only shows 3 wires....
Hello
I just came accross your post about replacing the Leetro MPC 6515 controller with Ruida 6442 controller. I have a laser machine with the 6515 controller which has stopped firing the laser but...
Hi
I found a solution to this, its not possible to reduce the nodes in vetric aspire. I start my design in Corel Draw, but instead of saving your design in DFX, DWG or AI, format. save your design...