Search:

I am running that dell optiplex with my Taig/G540 setup Running Mach 3 and use Cut 3d to make some 3d parts..No Problems at all

Taig Owners Club is giving away a Mach3 license in a free drawing

Kbillan.

Congrats on winning the Sheetcam Software on the Taig Owners Forum

have you tried it to see if it might be a Software Problem?

after some searching I will make my own with 80/20 material and 1/4 inch coroplast for the sides and back ,plexi glass front doors, Thinking of leaving the top open , not sure yet

Thanks

We need 42 inches wide for the Taig


as fretsman says 30" High X 26" deep, X 42" width would be perfect

I am looking for a Free dxf to g code software that works, tried ace converter but it don't work on my computer....

thanks

I went to the lococnc site but did not see any,,sent them an email

Yes using a pond pump...

I want to purchase a Enclosure for my Taig Mill, I know I can make one but barely have time to make parts, Plus I want it Nice if you know what I mean

I seen IM services makes one but its not wide...

Got it guys.....when I switched to epp I never tried engaging the motors again just seen the red fault light with the power on

Dan at Camtronics just emailed me and said it must be engaged for the...

just got my 540 Driver box from camtronics and my red fault light stays on and motors don't work

I tried a different paralell cable that I know works, switched to epp in bios and no luck, port 1...

mine says it too...how do you change it

Nice

If you Really want a good setup....sell that driver box and steppers on ebay and buy a Gecko 540 setup with steppers......

Your disapointment will be gone.........

Someone Really needs to offer...

when I tried to run your program I got errors at those I and J lines saying no radius implemented....

it lifts because your cutter comp moves are not right....look at my example and try to program...

also no radius values here

be carefull here ..you are rapiding into the part

Tack ..you need to do a prep move 1st like this example to get cutter comp to work correctly....Do your prep move above the part

G54 G90 G40 G49 G80
G0 X-.35 Y-.5
G43 T1 H1 (.125 em)...

you set your Z zero at the top of the part and set your XY zero where you have programmed those axis's from.......

Thanks we figured it out today........you must have been refering to the brass nut in front of the coupler.....they were loose too

Got it back in within .0005 on Y and .001 on X .001 on Z...
...

Thanks Gerry.......Also with your help on leadin for Cutter Comp...:D

Dang it......on my Brothers Screen name........Bullseye

I checked the Couplers and they were loose but I still have .016 in X .012 in Y
.015 in Z......


What is pre-loading the angular contact bearings in the motor block interface.

don't quite...

How do you get Backlash Compensation to work correctly.....

I keep getting a little gouge when it comes to a spot to compensate.....

I tried 10% and 20% in speed with no change and I have .05...

I have a Syil Super x3 that is about 4 months old but is used almost everyday and now I need to Adjust my backlash...

How is this done...I have .038 in X and .027 in Y...Z I have .032

I have...