Search:

Yes, this is a viable solution but only for smaller projects. Thank you for the reply.

Yes, you guys get me! So since I at the final design stage before starting construction of my table I wanted to know what distance you would use?

- - - Updated - - -



Exactly, this is what I...

Thank you.

Interesting. Thank you. My router will be fixed in place so adjusting it beyond the 11" of travel is a redesign.

Thanks for the quick reply. I have mine currently designed to sit 3/4" above the spoilboard. Hopefully we will see a lot of suggestions.

I am finalizing the design of my CNC table and I needed some input on what the optimal distance should be between my router collet and my spoilboard when my Z-Axis is at its maximum lowered position....

Doorknob, thank you for all of you help! I was finally able to get everything working properly. The problem is that I was wiring everything using the "Yang" method according to the driver...

Understood, your response makes perfect sense. However, can we conclude that all of the motors are functioning properly since each one of them behaves the same way with the driver that is working?

Doorknob, I am hoping to have some time tonight to be able to run through your troubleshooting suggestions as you mentioned in your previous post on this thread.

Before I did so, I just wanted to...

Thanks Doorknob for you consistently reliable response and for the troubleshooting suggestions. I will perform the testing you mentioned in the next couple of days and post back. I do not have an...

Now that I started to use my new breakout board I have had some limited success. However, I have come to the conclusion that my drivers may be bad and I need some input to determine if my assumption...

Hey Robinnn, I just strated using a new breakout board because the one that came with my kit did not have any inputs for manual controls.

I do have documentation I found in this forum for the...

Thank you so much for all the information you provided to me Doorknob. I believe that I have enough to go on for now.

I plan on using the new breakout board from now on which I hope has better...

I failed to ask this question in my original post.

If you notice from the pic of the motors I am using the motors are rated at 2.0 amps. I will be using 5 motors in my CNC and each power supply...

Thanks again Doorknob, you have been a big help.

I will try and find a 5V power supply lying around the house and wire it up to the breakout board. Do you have any idea how many milliamps I...

Doorknob, thank you so much for the detailed and informative responses. I have attached the documentation for the breakout board to this post. Hopefully this will provide some information to help...

I'm undertaking my first CNC build and I need help wiring up my electronics. I purchased the motors, drivers, breakout board and power supplies as a kit so I know that they are all compatible. I...