I am looking for a manual for the Jones & Shipman 1300 series cylindrical grinder. I need to know what grade of spindle oil i should use. Cheers
Type: Posts; User: tallenttoolroom
I am looking for a manual for the Jones & Shipman 1300 series cylindrical grinder. I need to know what grade of spindle oil i should use. Cheers
I would be grateful for the manual for this machine as well or at least the basic rules for power settings.
I could do with the NC graphics depocam software as i have the paralel dongle but lost the instalation CD.
Top job mate.
How did you get on with your upgrade?
We have just left ours as it is but mounted the monitor above the controller.
Take a look at the PDF in the earlier post. My cable is set to the "cable normal" setup.
With help from the members on this thread I managed to setup my PC directly to the Robofil510 with RS232. A seriel DB25 on the Robofil side and a DB9 on the seriel port on the PC with Belden seriel...
I have found a company that delivers an LCD replacement kit that's just a straight swap. £550+ Delivery.
Thanks for the advice underthetire.
I got confused about the ~1200 but reading again i see...
The screen lines were waving about the screen like it was haunted. It then just gave up about three month later.
What do you mean by ~ 1200?
The graphics crt screen has died on our Ultimax 2. We are currently using a 17" LCD PC monitor on a table next to the controller to view the graphics but we want to replace the screen properly with...
Thanks for the advise but the problem is with win7 seeing the parallel dongle.
The software does load.
Thinking about downgrading the OS to XP.
We are currently using Dexter Systems PEPs V3.1 (old i know) to create our cutter paths on our Robofil 510's.
The problem is that our replacement computers are windows 7 32bit Ultimate and we can't...
I have set-up the machine exactly as it says and am trying to use hyperterminal but with no luck. Does your machine have the same settings as the set-up guide?
Thanks very much mate.
There is another item you may be able to help me with.
Rather than setting the machine to receive and then sending from the PC. I was hoping to be able to select DNC from the...
I am wanting to link our Robofil 510 to the PC to transfer files rather than use floppy disk. I have the Belden cable and the 9 pin and 25 pin plugs but need the pinout info. Also could someone...
As soon as we called the local Hurco engineer he told us it was a spindle drive fault which we had to send the drive from the cabinet to him so he could repair it. £2000 He said it would get so that...
I get a SERVO DRIVE FAULT ON AXIS S when the machine has finished a cut and is retracting to tool change. I think its at the point where the brake should come on. Can anyone help?
It does is 8 times...
Sometimes it works and reads discs then it wont. Can i replace the floppy drive with a one from a PC?
Sorry i don't know which version controller we have. How will i find out?
Sorry its a Fadal CNC 88HS
We have a problem with our machine. It will not read discs anymore.
We get baud rate detection fail.
Can anybody help????
Thanks for that. I'm sorted.
Out of interest does anybody have the full set of codes??
Does anyone have a list of Aux codes for the Robofil 510? I am especially looking for the code to bring the pumps from sleep mode. Cheers.