Saw a post over there to show how to thin paths from a jpg
www.fullspectrumengineering.com • View topic - Vinyl software that works with Retina Engrave!
...
Type: Posts; User: ShortRunCNC
Saw a post over there to show how to thin paths from a jpg
www.fullspectrumengineering.com • View topic - Vinyl software that works with Retina Engrave!
...
Hand code:
1 the turret down to position
2 move the B to posittion
3 feed into main spindal
4 feed out of main spindal
5 feed into sub spindal
6 feed out of sub spindal
7 repeat 3 to 6 as a...
I have seen this machine grow in X as it warms up. For ours, we have a warm up routine that we let run for 15 minutes before doing any work on the machine.
Then again, we are in a snow area, so in...
I can offer you one bit of advice on a career change, simply, do what you enjoy and the money will come. I see it this way, I am lucky to get paid for what I do, becouse if I didnt I would still be...
i had similar issue, was actualy the limit prox sensor, had to adjust it.
Can someone tell me what item or items I need to change in an MDD file so as I can use the utility process?? I am trying to get the sub spindal to come in and pull are bar.
thanks for anyhelp
Does anyone have a .MDD file for Gibbscam that would be a good aproximation for our 2000SY machine?
I cant seem to get the utility function to work, says my mdd file does not support it, and I do...
Does anyone have a post for a Makino a51?
I am having a lot of trouble rotating the pallet, and the pallet deciding on its own which way to go.
Sorry it to so long for me to respond, been busy with the show circuit.
I dont know what my budget is, however, I have never had a problem paying fair value for fair work.
I have found someone...
Yes we have, several times, we even tried to pull the battery out of the servo driver.
The servo driver has a mode button on it that is not doing anything, as if its jsut not working, this may be...
We have a Daewoo Puma 2000SY, and the tool turret is stuck at tool 15!
Its just a 12 tool turret.
Anybody encounter this????
Service rep, not to helpfull, claims there must have been a T15 in...
I use a program called sketchup when I model a proposed floor plan, dont know if that helps you or not.
I am looking for fiberglass, clear would work for my mockups, in clear I would probly only need 2 or 3.
Production run would require fiberglass though.
I have attached a .IGS, you can open in...
Could someone point me to a person and/or shop that can make a canopy for an r/c helicopter?
I have the model in SW, but cant find anyone to make one.
Forgive me if this is in the wrong section.
I need a post for Gibbs, for my Puma 2000SY with
Control Fanuc mti-tb
MTA Super80 Bar Feeder
any help would help.
I have a small issue, I need to know how to convert from Bytes to Feet.
I know this might not be a direct conversion, like bytes/x = feet.
I assume the length in feet is from the old tape...