Search:

we have an older komo router with a general numeric control and eg&g drives. We are getting a 410 fault in x axis the position deviation amount during stop is greater than the setting value. we have...

We have a RH30 with a cent 7 control we started it this morning and are getting a error code #1. powered up and down acouple time did not help. any ideas. thanks

that must have been it becouse it quit

thanks for the reply

we just got a mm18 in. after getting it all set up, hooked up air and have an air leak thru the spindle. what would cause this and what is the fix.

thanks for any help.

I think it's a shazuke retrofit with a miltronics control. We where on the phone with a tech he said it could be the brake also. I think the boss is having them send someone up. thanks for the reply.

we have an alarm #409 z axis excess error code. we replaced z axis encoder and new drive board and still get the alarm.

getting burnt out and would like to try something new

email [email protected] for complete equipment list (put machine shop in subject line)

this is on a 98 fadal 4020 vmc with 88hs control and baldor drives

came in this morning and powered machine up had a servo error #18 on z axis while trying to get rid of error now have on all three axis same error. machine ran fine day before . we do have some...

2004 puma 240L fanuc 21i-TB we had the servo battery go bad 3.6 volt. we replaced that yeserday ran the machine turned on and ran today for an hour then we got alarm 2023 (not locking in the 10 sec...

Well-established metalworking machine shop business located in the west central area of MN. This is a turnkey business with everything a buyer will need. 3 engine lathes, 4 CNC lathes, 1 cnc mill, 2...

I used the first one

works great thanks

I have a few hundred parts that need five ops on.c' drill, 2 different size drills, c' bore and tap. I want to set them up in three vises and use fixture offsets. But i want to run all three with c'...

turn main power on we have voltage. push the power button and the servos and the screen do not power up. this is on a 1994 fadal 4020 88hs

we're on 55 down by john deere and the old case IH buildings

we have entered our slow time again www.bodmac.com

please send drawing to [email protected]

thank you
mark banks

found it. it was a bad limit switch on z.

no live tooling. it's about a 1983 model hitchie seikie.

turret will not index in program, mdi, or push button. can manualy index by pushing silanoid buttons. i'm thinking it has to be a relay becouse there is no voltage getting to the silanoid.

whats the differance between rigid tapping and regular tapping?

how do you draw something 2x or 3x larger than actual size

ran good for 5 hrs. shut down with error 3079

we started are machine run a dozen parts. it shut down restarted and we get a alarm 3079 if we try to curse across the program or call up a line. if you start it up and let it sit it will shut down...

yes that took care of the alarm 70 (mem. mode clear and erase) my guy just did the same thing on the first machine and it looks like it cleared that one up to. THANKS

swiched boards back now first machine still has alarm 3079 and machine that was running has alarm 70.

we tried unplugging bat. did nothing. we have another identical machine so we switched that boards. then we got a alarm 70 memory full?

i'm getting an alarm 3079. can't do anything in edit.it's on a hitachi seiki 4ne-600 lathe