Search:

My current cnc plasma setup includes CandCNC electronics (DTHCII and HyT Connect package) controlling a Powermax 85. I've been using Hypertherm's recommended cut settings with shielded machine...

Thanks Jim,

This answers my initial question. Here are two more that I need help with.

1. What's included in the Sensor PHC kit for Powermax Bundle? According to the Sensor PHC manual it's:...

I'm a partner at a small furniture shop and we're gathering research to convert a Machine Tool Camp 4x8 CNC router into a CNC plasma (DeskCNC operating software). I've spoken with Hypertherm several...

Fred,

I currently run DeskCNC on my 3axis router and I'm interested in converting it to CNC plasma. Sorry for digging up this old post, but you mention the "Feed Hold" pin. I haven't seen this...

Thanks for the suggestions. I'm currently rethinking the design to include more support for the table—a torsion box is definitely needed.

Justin

Thanks for the suggestion. I have my racks and stepper motor running on the inner T-slots of the long spanning beams. This makes it difficult to do anything in this area to add stiffness. This design...

Since I completed the Machine Tool Camp 4' x 8' router build last summer, I've been frustrated with the deflection in the table. The machine does quite a bit of flexing over it's length and width...

Until recently I haven't used my machine for projects that took more than 1hr of continuous router use. However, recently I had a faceted surface that put my Bosch 16171 in use for over 6 hrs. As I...