Does anyone know what tool holders that are compatible with the Dorian QITP35N tool post? The QITP35 type tool holders seem to be very expensive and was hoping for an alternate tool holder that can...
Type: Posts; User: Rivethead
Does anyone know what tool holders that are compatible with the Dorian QITP35N tool post? The QITP35 type tool holders seem to be very expensive and was hoping for an alternate tool holder that can...
Just a thought. If a person sets Z zero on the Top of the part and makes a couple of cuts and then the tool breaks how do you reset the new tool when there is no original Top setting point since it...
Does anyone know if running a milltronics partner 1d on single phase will damage the VFD ? The machine originally was run on 220v 3 phase. I hooked the machine to 220v single phase using one hot...
Hello. I have a question. I hooked up the machine like this it but will running on single phase harm the VFD? I read somewhere that VFD’s are 3 phase. The VFD I have is a Safetronics G3. Here is...
I have a milltronics partner 1d with centurion 5 controller. Wired it up to single phase 220v, turned it on and got this screen. Says insert Boot disc in drive A. Anybody know anything about this?....
The large transformer below the disconnect switch is wired to the zero terminal and to the 260 terminal. I have a 220v single phase outlet in my garage. The voltage across the two hot wires measures...
Thanks sportybob for the info and the drawing. It helped a lot.
Does anyone know what size rating of capacitor that this power supply uses that is missing on this board? The power supply board is from a milltronics partner 1d. It originally had 3 capacitors but...
What does CSP 3 speed spindle drive mean? I have a milltronics partner 1d that has 3 pulleys for speeds. low, med, high. Can this machine run on single phase 220v?
Thanks for the chart. The chart says partner models VM15, VM16 ..... I guess the partner 1 series machines fit these studs also. Am I correct on that? Thanks for any comments. 🙂
Hello. Do you know what retention knob a milltronics partner 1D uses? The serial number is 1907-901. Date is 204 (1992). I called milltronics and they didn’t really know but said it uses...