Search:

It seems well lubed with vactra no. 2 and I've been lubing extra as I've been investigating this problem. What's special about the Dexron ATF? I'm happy to give it a try.

I have a 1999 Bridgeport VMC800 with Fanuc 18i control. I've been getting an over-current alarm 436 - Soft Thermal occasionally on the X-axis and I've figured that it only seems to happen when I have...

Did you ever find a copy of the programming manual online? Did you get the pull studs from Dyna?

I want to machine two mating parts in 6061, one with a female dovetail and one with a male. I plan to use the common 60 degree HSS dovetail cutter. It seems to me that I can't mill both sides of...

What will the processor level say if its an 88HS... 88HS??

Thanks much,

Aaron

thanks... At first I did not find the Fadal forum but now I have posted it there.

Is it possible that a Fadal machine that was re-manufactured by Fadal in 2002 has an 88HS control inside the original CNC-88 case? Was it standard practice to upgrade their controllers when they...

Is it possible that a Fadal machine that was re-manufactured by Fadal in 2002 has an 88HS control inside the original CNC-88 case? Was it standard practice to upgrade their controllers when they...

I'm using several G201's driven by a Galil motion controller. The Galil can change whether the step/dir pulses for each axis is active high or active low. I have some configured as active high and...

Hmmm.. so its that simple? Just run the ground out to the common instead of the +5v? Also, as far as the overheating goes, I understand that the 203v will keep the motors cooler when they are in...

I was thinking of using some G203v drivers in place of some 201's, since I've already fried a couple in the past(overheating and reversed DC polarity) and want to have some spares around. I am using...