Thank you for your advise ! Why should I put the pd03 to 400 ? My spindle can spin from 8000 rpm to 24000 rpm, that is why I putted 133,33 hz for pd11.
Type: Posts; User: sigurimi17
Thank you for your advise ! Why should I put the pd03 to 400 ? My spindle can spin from 8000 rpm to 24000 rpm, that is why I putted 133,33 hz for pd11.
I finally could spin it !!!
All I had to do is to turn off the hard limits on cncjs with $limits/hard=off
So here are my parameters :
pd01 : 2
pd02 : 2
pd03 : 0
pd04 : 400
pd05 : 400
pd06 : 2.5
pd07 : 0.5
pd08 : 220
pd09 : 15
Ok thank you !
I will try and check the parameters tomorrow. I'll let you know.
Yes my spindle is 220V. I will try to put those new parameters. Thank you !
And no I didn't try to control it with Mach3. To do so I need to change a jumper right ? (RS485 to PWM)
In the end the guy explain how to control the spindle with an RS485 USB adapter connected directly to the PC.
My spindle is a 2.2kw water cooled 400hz.
Hello,
I am facing an issue with my huanyang VFD and Spindle. When I try to control it with CNCJs the spindle turns 2 second and then stops. After that I have an error message that is something...