Search:

We do have varying degrees of "clean rooms". All of which food is restricted. At that point there is finger pointing from the restricted areas and non-restricted areas. Very hard to please everyone,...

Hi Everyone,
This could be a touchy subject to some and a no brainer for others...
I work in a shop that machines parts for mostly medical and aerospace industry. I would like to know what is the...

What types of liquids are ok? (water, coffee, tea, soda)
Must they be covered? Difference as in an open can of soda vs, plastic soda bottle with screw-on top?
Since you have just implemented this...

What I did find out when I got into this further is there are 2 kinds of G68.1
There is 3D coordinate system conversion, and there is 3D Coordinate system rotation.
The machine came standard with...

Hello all,

I've been tasked with the challenge to do some angular milling on our Tsugami BH-20, Fanuc 31-i Control Turret Swiss machine.

I haven't done this before, so getting the correct...

That all depends on the versatility you're looking for, and what programming/setup experience with what Brands.
Most of the machines mentioned are all in the same class.
Most of my experience is...

I was just reading through this thread now, BUT I and am curious to see how it worked out for you.
I ran it through using NCplot, it seemed to work just fine.

#120=1
#7=1

IF [[#120 EQ 1] AND...

Worked like a charm :)
Thank you Scott,
Jurell

I gave it a shot, but it added unwanted tool path. to the x and z coordinates in your subprogram.

I had the best luck just taking out the G32's - keeping all tool path in G00
then changing the...

The G32 isn't an actual cycle. More a spindle rotation sync with the given feedrate for the axis movement per line.
It just errors when it reads the G32
I could replace them with a G1, or just take...

Hello All,
I am a new Forum user, but have had NC Plot for some time now.
Some of the macros I try to plot use G32 commands and NC Plot doesn't seem to recognize them?
It seems to recognize G92...