Ok i was told to get motor a06b-1003-b100
and
control a06b-6044-h007
does any one know the difference of the a06b 6044 h008 control?
Type: Posts; User: t-runner
Ok i was told to get motor a06b-1003-b100
and
control a06b-6044-h007
does any one know the difference of the a06b 6044 h008 control?
ok i had my brother take the control to the place i found online to have it tested since i have a day job too. The place was in a bad neighborhood and was a house, i woulndt mind if i had been told...
My current boss has a megger at his.rock crushing company which.i.am trying.to get ahold of could take a few weeks, ill keep you guys posted, i have the spindle control out amd am trying to get it...
It seemed to run really smoth, And I will check A H J and K to ground, I think I already did and had no opens. But ill double check, also I pulled the spindle drive and will have it tested tomorrow.
Ok with the battery test the motor turn at about 100rpm, does that sound right
i will test that tomorrow.
also please way in on my options at this point.
1. I am almost at a dead point here, i try to work thru it but it could take awhile and all my free time.
2. pony...
It will not run at low speeds
And do I hook A to positive car battery and H to ground. And J to + and k to -,
also thank you for taking the time to write me.
i clean had pulled the motor off in hopes on taking it to a local motor re builder and having it tested i have not found a close one yet.
while it was off
-i cleaned the brushes and brush...
neliw20 i will try to do what you said but by the sounds of it i will more then likly have to call the tech in.
al the man, i can pull it part and clean everything, i can see how much the motor...
how do i measure that across the windings? i know alot of questions. sorry i just dont want to do it wrong and rule something out if im not sure.
also a tech told me field side of j to k should...
how do i test inductance?
i have no idea why but in the back of my mind i just felt like the motor was bad.
how do i test the fanuc model 3 d.c. motor.
thank you everyone i have been trying to figure this out for...
ok so if that is low what does that mean?
where do j & k go to? the spindle motor? what do they do. are they the power wires?
ok with j&k disconnected from the board. and measuring the board side i get
78 volt D.C.
and on the wire side 0v d.c. and 3.4 ohms
also when do i check the voltage just when the machine is on?
or try to turn the spindle on and then check it with it alarmed out?
and when yu say across j and k feild do you mean on screw...
and i was hoping you would chim in al the man
i believe the resistance was 244 ohms not k just 244.
Volts between j and k is 8.9v dc
i will get that voltage and get back to you. Thank you i am really stuck on this and dont have the money to commit to $100 an hour plus drive time for a tech to come out. and spend a few hours then...
i have a kitamura S-12 and yesterday i went to start the spindle and it turned a few degrees then instantly throw a alarm. no alarm on the screen but on the spindle drive board l.e.d. #2 was on...
what machine, and what controller?
Have your tried the code? their are a few blanks for tool number and height offset change these your desired tool number and H offset and it should run, also remove the double spacing. and at the...