Replace the CENT_PROCMOD put parameters again and this started working.
Type: Posts; User: Renatox_
Replace the CENT_PROCMOD put parameters again and this started working.
Hi good day,
In a Kitamura center with 11m fanuc control, when i turn on the control the following menu appears and the operation panel does not start.
FS11MF 2122Q
Romtest: end
Ramtest: end...
I could solve this problem, replace the batery of 6v, i put all the constant, then this almost work.
in test obtain alarm of Drive mod3, Input Module1, CentPro. , this look like electronics error...
Hi good day i am checking cnc mill MH500C with control CNC 432, i obtain the errors M01 and I01,
If 19RSS1 = 0 , error M01 appears (checksum fault MC memory RAM)
if 19RSS1 = 1 , screen constant...
Hi good day, i have saveral servos Z15-1-240v, as photo sample.
I no have the manual and connection, i would use this for drive other motors. Some you know the connection this have X6, L1, L2, U,...
thanks, the pcb original is fault, i put these and chessboard same appears, i put the centr. proc. mod of the other maho and error M01 appears, as you say, this can be parameter, i no have form of...
Hi good day,
I am checking a Maho 500c, this have Philips cnc 432, the second pcb of the side left is Centr. Proc. Mod have fail, i remove this and screen have the form of chessboard, then i put...
HI viorel23cnc, the arameters o constants for MAHO MH500C, have you this?
thanks
OK thanks, refer a 5um/meter, it is ok.
Renato
I all, I have a MAHO MH600E cnc 432, but no can move the x axis, this say Alarm X02: (Alarm measuring system fault), i suspect what is the encoder model AE LS 403 Heidenhain.
Seeing the datasheet...
The voltage source of 15v, internal control, has been damaged, the reason was a short on the source wires that go to the turret. What I did was put in parallel, out of control, a switching source...
Thanks for the data.
I have three connector air, and four connectors in the A06B, these are:
JX5
JX1A
JX1B
PWM11_JV1B,
the connector terminating is connected a JX1B, the other a JV1B and...
Hi good day,
I was removing the connectors of 20 pins of these drivers A06B-6079-H105 and i lost the terminating connector.
I guess this take a few bridges, i can see the datasheet and...