Search:

Thank you James Newton :) I knew you're a good person. I am just new to electronics so sorry for so easy questions for you ))
I will try do cut the line to pin 3 and if needed to add the resisor. I...

Thank you so much lucas! I will buy driver and try to find what to disassamble ))
By "torque pin" you mean pin 3? and by "torque input" pin 5? So if I give 5v to pin 5 i get 100% holding and...

You're the best sellers and still forcing too much )) I just need advice at questions I asked. Are there any good people at this planet? Helping me it's just few inputs from keyboard. Thanks.

Thanks for reply James Newton!
As I understand current reduction mean that it's easier to push/pull shaft of the motor. So motor runs at full current and can lift 10 kg weight, then it automaticly...

I see that 3-d pin of TB6600 is Torque (output current) setting input pin. Does it mean that I can unsolder it from driver pcb to get 100% of idle holding torque? I do not see any switches for that...

Hello! I have also two questions.
1. I used cheep chines TB6560AHQ driver before it burned out. It had small idle holding torque. So ~175oz/in motor will lift 1 kg up (on 8cm wide shaft), but later...