Search:

Sorry for my mistake. Machine is ml60-A not 25
MTB manual says about M18 Nd M19 capabilities.

TURNING MACHINE YANG ML25
Control FANUC 0T

I was playing up with M18, M19 in MDI to stop spindle in exact position to facilitate to load unload part from spindle.

Now when I change mode...

Had no problem running/installing program but it wouldn't receive program. Some time i was able to upload a file but not download. I could use other softwares on windows but this didn't work
...

I could not get dnc-x working on any flavour of linux. It would not receive anything through serial port but may be able to upload.

parminder

On my Fanuc OT I use M198 P1234 and it runs the program through serial port. Try omitting 0 from subprogram number.

parminder

Actually my question was not Tape or Drip feed. It is about running a subprogram through serial port by M198 call.

We have done it. I'll post the parameters needed to change on wednesday.
...

I was told by an ex Fanuc engineer to change parameter 916 bit 7=1 to enable M198 call but it did not work.

As far as above softwares are concerned we can only choose a DNC software once we are...

I still have no luck with communication throgh M198 with machine.
I already have parameter 63 bit2=1 on as suggested by spark-el. Some body suggested 38 to be bit6=1 bit7=0

Has anybody have a...

On Monday I'll try with 63.2 I'll let you know if I succeeded. I'll wait for Adam's answer as well
Thanks any way for your answers.

Parminder

It is not M98 but M198. The reason for this is that I have setup an gauge system. We need to gauge the parts while machine running and its values will be stored in a computer. We want to auto set...

I need to run a small sub program from computer by DNC with M198 call.
Can any body tell me which parameter required setting?
I am using Puma with Fanuc 0T controls.