Good morning smile.gif
You have 2 possibilities:
1. Turn off Block search calculation. That has the disadvantage that you can only enter with the tool.
2. You enter under the set with the tool,...
Type: Posts; User: KAMIE
Good morning smile.gif
You have 2 possibilities:
1. Turn off Block search calculation. That has the disadvantage that you can only enter with the tool.
2. You enter under the set with the tool,...
The serial number is positioned under setting number 26, key Setgraph -->general --> Nr.26
Greetings michael
The serial number is under setting no. 26- button Setgraph – General- no. 26
Regards
Michael
Hello dekas,
The Bill time Code is entered with the serial number. Usually there should be an instruction with the code that states where and how to enter it.
Greetings Michael
Hello dekas
The bill time code is entered with the serial number- usually you should have an instruction with it that tells you where and how to enter it.
Regards Michael
Hello Namensvetter :)
Thanks for your reply. But I receive this error message also when the path correction is turned off. No matter what settings I use, this error appears again and again. What I...
I receive the error message "Lead-In missing to output NC-Compensation movement" while contour turning with SolidTurn.
Could anyone help?
Regards, Michael
I’ve also had such a problem. If the voltage is ok, it may be possible that the voltage monitoring is defect. You can turn off this monitoring. But I don’t know how. Haas-Service made it for me....
So, I have 4 different machines and 3 controllers.
These are HAAS, Gildemeister (EPL2 and EPL10) and Haidenhein Manual Plus,
I prefer to work at the Haas.
Regards Michael