I know the original post is ten years old but I’m in the process of setting up a chnc iii with a bison chuck . I can’t find any info . Can I cap the air lines to the collet closer and turn off a...
Type: Posts; User: Chopdr230
I know the original post is ten years old but I’m in the process of setting up a chnc iii with a bison chuck . I can’t find any info . Can I cap the air lines to the collet closer and turn off a...
Looking for tool changer parts or an entire parts machine . Miyano tsv-35 . Bt40 taper . Probably a long shot but thought I’d give it a try . Thanks
I have a mill with fanuc om-c . I would like to activate the DNC function . The machine dose not have a tape mode switch or any switches in the cabinet to activate it . There dose not appear to be a...
im trying to figure out how to program this machine by following the program manual . my problem is I didn't have the O9801start position program . some nice people on here gave me there copy off...
alloy craft I was in the same boat . my machine came with a dead battery . google translator worked wonders and its free
Would either of you happen to have the setup program and O9801 macro the nomura program manual calls out ? I recently got a NN13 with a dead battery and had to reload everything . I’m new to Swiss...
I have a nn-13s I’m looking for the macro O9801 used with the setup program .
When I press the fo button the page is blank. I’m trying to get to the tool position base page .
I have a nomura lathe with the meldas control . When ever I try to home it out the y axis hits the emergency stop and kills the machine. I tried to adjust the soft limits but nothing works. Could it...
I’m getting a feed hold alarm (212 support no act ) on my nomura lathe with a meldas 64 control. I tried to look up the alarm but it’s not in my book ? I can jog x and z but y is dead . No other...
I have a 1kw delta ac servo drive and a .75 kw delta motor . will the drive only put out what the motor draws ? or will i burn up the motor . can you mix and match drives and motors ? i know in a...
Hi i have a miyano tsv-35 and it dose not have tape or dnc modes , no switches on the control . I am able to see the ladder and searched for g127.5 and its not there . Is it possible to have it added...
Hi my name is AL I picked up a tsv-35 that needed some help . I have spent the last two months trying to get it up and running. I had to replace the power supply and crt wit a lcd . I’m still having...
Al I need your help also!! My name is also AL . I can’t get the website to work properly on my phone. That’s not my issue but that’s why I can’t contact you. I have a Fanuc on question....
This machine is new to me . I put the atc in manual and zeroth to its full upward travel. I got a tool alarm 22 . Now z won’t move in any mode and I can not home the machine . I have the parameters...