Contact to [email protected] They will help you with parameters
Type: Posts; User: metalcutting
Contact to [email protected] They will help you with parameters
Hope it will Help you
G00 Positioning
G01 Linear interpolation
G02 Circular interpolation – Helical cutting (CW)
G03 Circular interpolation – Helical Cutting (CCW)
G04 Dwell
G09 Exact stop...
Take Help from [email protected]
you can take support from [email protected]
Hi Every one ,
I have one Sharnoa VMC HPM 24 with tiger 5 control , The machine is running in Inches how to go in mm Mode ? Please help
Please share your machine serial number and year of Manufacture by PM
Please contact on [email protected]
communicate me on [email protected]
Its very easy to repair , It has fuses , relay , a power contactor and PCB Fuse , If any help required let me know
you want FLOPPY DRIVE EMULATOR make Haas or any compatible is ok to you
is it CRT or TFT ?
Make motor off line and put +05 -05 v in phase to phase and see the voltage dropping phase to phase and compare to earth
TRY M 40
M 41
or check the motor
Please check the input fuse of drive , than breaking resistor , and control voltage if all are ok , than check the scr module , alarm is of spindle or E stop ?
Check the Motor cable and axis load , Jog in Low rpm and check the load
you can use 60 Hz even it wont will effect the components , but 50 Hz is better while using in PWM and Phase shift circuits
Both are alpha series pulse coder you can use
; start with it
check the control circuit and wiring , also check the control voltage
ENB 1 AND 2 ARE ENABLE SIGNAL WIRE VCMS FOR VELOCITY MASTER SPEED, NEED THE DRIVE PICTURE FOR CONFIRMATION , WHAT 'S APP - +91-9384248184
what is the ROM version
check the option param
Look at :
http://www.cnc.info.pl/files/a2100_operating_manual_166.pdf
http://ftp.ruigongye.com/200807/91204426a001.pdf
- - - Updated - - -
Look at :...
Take mitsubishi vfd . Its easy for hobbyist
Is it turret punch ? or
here you can get the Parameter and maintenance manual
Fanuc 3t Manuals User Guides - CNC Manual
For Operator manual Give me some time I will scan and upload
Is your machine with Fanuc 10 MA ? or else ?
Useful link :
https://quantumautomation.wordpress.com/
One For Programming
and Another is for operation , For TB Series 62554e is the correct manual
After power up you use Handle / MPG towards negative direction to axis movement First
Or do Grid Shift arrangement as :
https://quantumautomation.wordpress.com/2016/06/07/grid-shift-adjustment/