Search:

it works after aligning the portal. thanks :)

every homeming doesn't work? is another profile needed just for alignment?

PLEASE NOTE: Before using the gantry square method, the user must configure the master and slave motor outputs and their corresponding limit switch inputs.

Master slave axes have the same...

the end stops used are inductive proximity switches, the question is how are the 2 motors addressed separately when homing?

I would like to use 2 motors and 2 end stops on the Y-axis on my portal milling machine. my board is the MK3/9 with current firmware, how do I define these two motors including endstops in the...

connecting the driver outputs was simply connecting the + pins to the board and the GND. already I don't need a rotary encoder

hello this is a diagram of the connection of the servo controller which pins (numbers) have to be connected to the MK3

Thanks I'll try when I get a chance

Hello, I use the MK3/9 card for a lathe, I want to reference the X, Z axes. X is Min, Z in Max. The problem I have is that the Z axis moves in the direction of Max, and then with G0 to Min position....