Search:

I currently have a 2ft x 5 ft cnc and a 4pt x 8 ft cnc both running planet cnc software and they do great as long as you have your grounds right and use a short double shielded usb cable. They both...

I did what you said and unhooked everything then did reset and set it again. It finally worked. So now I can switch it off with the panel buttons. But I still cannot control the speed.

Thanks for...

With or without external controls, and trying everything I can think of, it will turn on just fine and run great, but I can't make it stop. I have tried various settings and still nothing. The only...

What type of switches should I use?
I know the panel buttons won't work in 3 wire mode, but I couldn't make it stop before I tried the toggle switches.
It's the same way either way I try it.
for...

Hello.......I'm still having the same trouble.
here are my settings......
PD013=8 ( I started with this reset and did the rest in this order)
005=400
004=400
003=400
144=3000
001=1
002=1...

Pd001 is set to 0. I think it may be a faulty button on the inverter. I'm going to install external buttons today. Do I need to use normally open momentery buttons or full on/off toggle switches? And...

Mactec54
Mine is set at 4 poles. Would that cause the pot and stopping issues?

Hello, I have set up my new Huanyang vfd with 2.2kw spindle. Firstly, the onboard potentiometer does nothing. But my big problem is that I can press RUN and it fires up and runs great, but the STOP...

Hello World!!!
I just installed a new Huanyang VFD and spindle on my CNC and I am having trouble. I have searched the WWW for help and no luck yet. I can press run and it will run fine, but I have...