Search:

6601.603/06

Inputs from the gear selectors are all showing/toggling in the PLC inputs page when pushing switches.

Now, when I am monitoring the outputs on the plc, when i press the execute button to run ref....

Turned out that it was the "tip saver" that blocked the movement. Increasing the tip saver % allowed the THC to control z-axis after activation of THC, since voltage usually was above the deviation...

I am running Mach3 and CandCNC Ehtercut with DTHC IV. There is an issue when ever THC is activated, eg. after a corner, and actual voltage is higher than the set point, it does not give any command...

As a newbie to this forum and MAHO as well, I will do my first post regarding this fine MAHO MH500C which I picked up a couple of weeks ago in a non working condition. I am hoping to be able to use...