Search:

Loosen the four lower bolts in the coupler. Drive the wedge out with a chisel in the space between wedge and main body. Motor comes out with coupler attached. Loosen the four upper wedge bolts to...

Has anyone replaced the x axis servo on the powerpath 15? The motor does not want to slip out. Not sure if the coupler needs to be loosened first.

still have that motherboard?

On start up it only flashes the monitor. I have noticed the monitor power indicator is on then off with the flash, no start up screen.
Pulled the main computer board, connected to power and it...

Has anyone had success with the tapping cycle? I have tried a G84 many times and only get strange results. Spindle and feed all wrong. Tried with dwell and without.
Is there an update to the...

Jay,
Excellent! If mine fails this is what I will do. I may need a copy of your notes some day. So far, mine is working. Other than the tail stock control deciding to go nuts one day, everything is...

I am about to try a puller on my powerpath. Did you have success? What type of puller are you using?

Nice set-up. I'm looking for one of those monitors.

I added the chuck clamped I/O to the viewing box and monitored it while the spindle ran. I noticed it was flashing "OFF" and back on immediately. Enough to trip the control
to shut-down. The light...

Now I'm getting the "chuck not clamped" alarm at random. I have watched the chuck clamp sensor during the run and
the light on the sensor is on before and after it sets the alarm and stops the...

I connected an old pc crt to mine. It does the job for now. I'm looking for a 15" lcd

I have not had any problems except for the threading being slightly off. The machine was like new when I got it a year ago.
The only other problem I have had is the turret not completing the...

The video board in the control head on my machine has burned out. Does your source have any?

With parameter 71, the Spindle Command Gain, set at 6.725 I was seeing:

commanded 400 rpm, actual (reported) 375
spindle overide set at 100%

After experimenting with the spindle command gain,...

The thread pitch is off on my machine, about .025 inch per inch of thread with a 16 tpi.
I have noticed that the rpm reported is around 12-15% off of the rpm commanded, ie. 144 reported with 150...

should have been O2001. This is a subprogram.

anyone had experience with coord sys rotation? I have tried to read in but the control deletes this block and everything below. "illegal program number"

G68 X0. Y0. R180.

trying to nest...