Vectric Aspire fully upgraded to V 9.0
Closing Shop, no longer need.
Vectric Aspire upgraded to Current Revision 9.0
VectorArt 3D collection1, flourishes and ornaments.
List Date: 7/19/2017...
Type: Posts; User: fcarpcarp
Vectric Aspire fully upgraded to V 9.0
Closing Shop, no longer need.
Vectric Aspire upgraded to Current Revision 9.0
VectorArt 3D collection1, flourishes and ornaments.
List Date: 7/19/2017...
Dave,
How did this project work out?
Frank Carpenter
It would help if you posted the 3DM file.
fcc
I can help with this. Send me a PM with your email address.
While we are at it, I've been beating my brains out trying to come up with a way to improve the Techno touch probe utility. There is...
Eric Feldman at ArmorCNC was a BIG help to me on this.
My machine is an LCX Plus with a I/O riser card coming off the processor card. On it are two 15 pin D-subs. Connect your normally closed...
I've just successfully completed a service transaction with Eric (bad encoder, replaced this morning) and am happy to testify both Eric and Mike are committed to keeping these machines alive.
...
T-splines pull to points?
Dave,
I can't understand what you want here.
On my LC 59120, the default ordinate system is facing machine front:
x moves the spindle on the gantry, left is minus, right is plus
y moves the...
Aspire has a very short learning curve, you can pretty much start making stuff without cracking the manual, the on line forum is active and dynamic. Aspire has 4th axis capability.
Enroute...
You might try Harvey Tool - http://www.harveytool.com for more info on small tools.
I've used their 2 flute ball end, lollipop and tapered rib cutters with good results.
I've only gone down to...
I have encountered the same problem with my LC 59-120. I'm currently running with 5 tool holders and have moved them all forward in the tool rail, then use the rear section of the table to run 5'x5'...