Search:

This really clears things up Mactec... Thanks.
Ignore my last post I must have been typing at the same time as you were leaving a reply.

Anyways much appreciated, thanks again.

Thank you Mactec and Baxter for the reply. Your replies really helps clear things up.

I guess what had me confused most is in the manual where 3 phase wiring is mentioned, do they really mean...

Hello,
I have a similar question and I will jump on this thread and ask here since it is on the same topic...

I also have 3 Dyn4 H01 drives and my shop runs on 3-phase 240v. Voltage measures at...

Hello JP.
Did you get this issue figured out?

I also have 4x Dyn4 drives with the 1300w servos (Z-axis servo has brake). They are installed on one of my heavier machines. So, it looks like I am...

(This is a re-post from my original thread on linuxcnc, in case anyone here is looking for a answer to the issue)

Seems like I got this issue figured out... Tested pin 15 as a enable pin and that...

Well seems like I've tried it all and still the drive will not disable. I've swapped drives with a brand new one, swapped i/o cables, checked every single connection and all pins with voltmeter about...

Hi PCW, Thanks for the all the very important information
At the moment, for testing purposes, I am activating the coil manually with the 24v psu for this exact reason as I did not want to damage...

Hi Alan, good to see you are also on here... Just recently found this DMM specific sub-forum and thought I should post my questions on here as well.

Thanks for correcting the diagram, I initially...

Hello fellow machine builders and CNC'ers.

I am building a heavy 5x10 CNC Router / Mill that is coming along very nicely and is almost finished. I just need to finish up installing and configuring...